- 986 wheel hop
- Motor won’t turn over – any suggestions?
- Parts for top mounts?
- TEIN EnduraPro Shocks/Struts? Thoughts?
- Throttle body connectors
- Electric power steering pump positions
- CAN-Bus not communicating with anything
- Digital Speedometer display problem
- Cat delete straight vs with resonator
- Problem replacing front wheel bearing
- Vogtland coilovers
- rear plastic leak onto ECU?
- M96 crank
- Heater fan not working
- Suspension Questions- refresh, dual purpose
- Front brake upgrade
- Chassis bracing - Ultraracing
- Physical difference in crank carriers from 2.5 to 2.7?
- Rear Toe Control Arm
- Ngk bkr6equp gap?
- Smoke Test result's
- O2 sensor cel
- Why new MAF for 4460 Code
- Unidentified connector in the front bay - any ideas?
- Audi V8 choice
- upgrading the stock cooling fans
- What do these Durametric number's mean
- Not Passing Emission Codes..1128,1130,1137
- looking for a measurement.on variocam tensioner .
- Litronic occasionally turns itself off?
- Brake and ABS light issue
- 1997 Boxster key doorlocks misbehaving- Suggestions to Diagnose?
- Replacing Catalytic Converters in a '98
- 99 2.5 Boxster - Oil leak back right hand side, above muffler
- Catalytic converter
- Pelican Parts Cars and Coffee FALL EDITION (Oct 26th - Rolling Hills Estates, CA)
- Coilovers or OEM m030?
- abs schematic
- Advice for buying 2K Boxster with P0410 P1411 codes
- G8620-103 (03 Boxster S 6-speed) manual transmission and LSD flush
- Part Number Needed for Cayman Rear Sway Bar that fits 986
- Grafting a Cayman roof on to a Boxster?
- Smoking amp
- Race/track alignment specs?
- Track alignment
- Heated seat relay id
- Need some measurements for the Alien
- 99' Boxster Keyfob Locking Mechanism Not Working.
- Looking for part in the IMS
- O2 weird situation
- Best / First track mods?
- 2003 Boxster S Newly installed Clutch System not Disengaging
- 986 Different ABS versions
- Good Oil Discussion
- Chassis Stiffness Torsional Rigidity
- Intermediate shaft plain bearing end damage
- What Model year is to New
- 2000 Boxster 3.2s Lightweight Flywheel - Sprung clutch options?
- 2000 Boxster 3.2s Lightweight Flywheel - Sprung clutch options?
- Importance of keeping the lifters organized
- Pelican Parts 4th Of July Savings 2024!
- DME No power
- Removing a "mushroomed" oil pump piston.
- 986 Boxster S clutch mystery
- I broke the LN Faultless IMS tool
- should it start?
- Brake hose / line when using 987 wheel carrier on 986
- Look what I found in the oil pan... any ideas?
- Help! P0444 - Purge Valve Circuit Open
- Engine swap/ a/c compressor problem
- chasing down P1124 and P1126 culprit
- Boxster S CEL P1126 and high LTFT
- Suspension Refresh - worth it ?
- Quick engine harness question
- V8 Swap PSM Wiring
- Scoring on the camshaft bearings
- Question About Fuel Injector Rail Pressure Test Schrader Valve Fitting
- Government grants to energy-efficient light
- Will this DME engine swap scenario work?
- What Hardware Needed for 964 RS Mounts?
- Spring / strut combination
- No power to heater display has me stumped
- Does Fabspeed setup pass emissions?
- Pelican Parts Spring Sale Just got BIGGER!
- Failed smog test
- Do I need a new brake booster?
- 2001 Boxster S Cranks but no Start
- Exhaust for 986 / 987
- The Winter of Carnage
- Reducing play in gearshift mechanism
- Pelican Parts One-Day Sale: HAPPENING TODAY MARCH 27TH
- Diagnosing a suspension issue
- Calipers indefication 986/987
- 99 986 2.5 - Idle air control valve not working right?
- Single-row IMS/IMS bearing in 2.5L M96?
- Cam chain tensioner pads from Hamburg Technic?
- 99 986 - idle air control valve buzzes but does not open
- Oil temp sensor/ level pinouts and plug type
- Problem with EEPROM 93C56 in cluster
- Top motor issue
- boxster engine rebuild
- How do you Build for Torque 3.2 Ltr
- No power to amp
- 987 ABS pulses/rev
- Diagnostic help needed! Hot film MAF and low oxygen adaptation.
- Location of bridge plug
- 2001 boxster s headers with auto trans
- Pelican Parts Cars and Coffee is BACK! (Jan. 27th - Palos Verdes Estates, CA)
- Anti-seize on engine mount brackets?
- 986 S Brakes are Breaking Me
- Startup noise?
- December Deals At Pelican Parts!
- 986 wheel uprights
- Replacing / upgrading cluster while preserving mileage
- Gas Smell through Air Vent in 2002 Boxster
- Changing the CPS (Crank Position Sensor) on jackstands
- Oil filter inspection advice needed
- 2001 986 5-speed dimension needed
- BLACK FRIDAY SALE 2023 @ Pelican Parts (Rennline, Eibach, Powerflex, Maxilite,+ More)
- O2 sensor codes
- Turn signal
- Pelican Parts 2023 Veterans Day Sales Event!
- Another Hard Starting Question
- Small oil leak, worth checking?
- Cam Sensor out of range bank one
- Ignition key help
- Help me understand Secondary Air flow routing through the cylinder head
- Wheel Fitment question
- Turn signal problem
- Lowered 986
- Wiring harness in an 01 base
- Ben006
- Audi 0A2 into base 986
- Is this Variocam issue?
- Reverse Rake after Corner Balance Normal?
- sirbag light
- Airbag module replacement confusion.
- Thoughts on Rear Subframe Braces
- What's the best Header for a 02' 2.7
- Battery Draining?
- My " Fred's " bi-xenon headlights both stopped working- help
- Replacing Rear Struts - Axle Nut or CV Bolts
- Top transmission gear upgrade. What’s the consensus?
- Cracks in rear trut tower
- Help needed, we can`t find oil cooler orings for the boxter 2.5
- How to Re-Torque Lower Control Arm
- No start or crank advise
- Repairing door lock module Part 3 of 3
- Repairing door lock module Part 2 of 3
- Repairing door lock module Part 1 of 3
- I seem to have a leaking oil cooler. (heat exchanger)
- alternative source for vacuum lines?
- Front ball joint post thread size
- Has anyone repaired a cracked coolant reservoir?
- Request for Valve and Valve Guide Wear Limits/Measurements
- Copper like sludge in oil pan + copper/lead UOA
- Dim headlamp low beam.
- brake pad cross-reference
- Fuel Gauge & Washer Fluid light
- Slow fueling/splash back
- 986 S engine rebuild
- Fixing The Start Up Rattle
- talk to me about case bolts ...
- PIWIS II How do I program key, immo, and DME?
- Radiator fans testing and engine temperature gauge
- SURVEY: Rennline Product Requests (Win a $100 Gift Cert!)
- No PSM and Open Diff???
- Hissing on throttle tip-in; vacuum leak? AOS? Normal?
- Soft top stops after starting to open and then will not go up or down
- Pelican Parts 2023 Memorial Day Sales Event!
- Boxter 986 bonnet dont open
- perhaps we need 6-1 headers?
- 2001 986S throttle, warm starting issues, could use some help
- Switching betwen two tunes in Motronic 7.8
- Boxster Wiggle
- Suspension Recommendations
- 986 Tiptronic Emergency Run, please help
- PMS OFF/ABS Light
- How to use a Durametric OBD reader on a Boxster.
- Trying to understand fuel trim... HELP
- 98 Boxster large oil leak
- Oil pump piston, some questions.
- Introducing: Pelican Parts LIFETIME REPLACEMENT!
- E85 stock / no flex sensor / tune.. ??
- Pinout connectors in the trunk 986.
- Did the 'poor man' OBC mod, cluster lights stay on
- LAST CHANCE To Save on April Promos @ Pelican!
- Racing Dynamics Strut Bar - Install + Info
- Digital Torque wrench,.recommendation's
- Differential leak
- Turn key and everything instantly goes completely dead.
- Gas on top of gas tank
- Interesting fact. A disconnected oil pressure sensor throws no code.
- Front Support bridge for coolant pipes.
- Transmission Skid Plate bolt p/n request
- Questions About Start-Up Rattle
- 2.7 Engine build options
- Coolant Bleeder Question
- Convertible top not opening, and makes a knocking sound
- Radio CDR 220 code problem
- Weird HVAC Issue
- Flywheel Bolt Torque
- Power Steering Leak
- newbe with air bag module question
- 986 still down on power. Thoughts?
- Cylinder 3-6 Cams Jumped Timing
- Can I use a 2000 911 case...for
- 986 2.5 No burble??
- H7 LED bulbs
- Two different temperature sensors... why?
- Failed (mushroomed) lifters on M96 engines?
- PSS9 w/ Rennline camber plates installation HELP
- No Rpm or speedo on cluster?
- Service Now error
- Sebro Coated Cross Drilled Rotors
- Non-Start Issue: Help Needed
- Paddle shifters
- replacing shift forks in a g86.20 six speed.
- Brake Caliper Piston Question
- Last(?) IMS thread for the year
- What can I do with this 3.2l engine?
- Vacuum line mysteries
- Engine and transmission removal
- Starters different between S and base?
- Aftermarket stereo to MOST Boxster
- Oil filter for IMS solution
- Pelican Parts Black Friday Early Access!
- Boxster 986 clutch
- Test port on fuel rail thread size 2000s 3.2
- ECS Coil overs
- Trouble shooting P0336 RPM circuit code
- Engine run stand.
- Engine swap help
- Timing Chain Guide Advise
- High Mileage Engine Out Questions
- DIY oil filler tube.
- Recycling a clutch release bearing
- 97 starts but not actually
- Looking for Transmission diagram
- Boxster 2.5 piston ring question
- 2.5 to 3.2 swap
- main brake lights don't work, third does
- Boxster S Coolant pipes on 2.5
- Engine removal, is really everything disconnected?
- Engine removal
- Under trunk heat shield fasteners, how to remove?
- Yes, Another IMS Bearing Thread but hopefully with updated info....
- Captive Nut Holding Diagonal Brace to Body
- MAF value off a bit
- Convertible top won't go down