BRAN's - 986 - Seal Gray Anatomy

[JBauer]

The reason I removed the covers was I watched the video on the site that sells the top and he shows vaguely how the should go in. In the video he has the cover removed and I thought the black molding. He just had the covers off, Hus demo Boxster didn't have the molding painted black so I misunderstood. As for the top its definitely the problem. When I removed the top the primer was smashed into the top all the way across the highest edge. I put the lift gate on it and the top it preventing either side top slip into place. Even with alot of downward pressure it wasn't even close. As you can see in the pics it should fall into place without trimming because it is narrower than both of the metal ears. I'm not sure why my top is like new and hasn't ever been a problem. I'll try the spinlocks attached but they are pretty far forward of where the interference problems is. I dont mind taking the top off for I plan on leaving this top on for awhile.

Thanks for your help!

[BRAN]

Originally Posted by JBauer

...

Thanks for your help!

Oh, you are welcome!

[JBauer]

It fits alot better now but I believe the ears still need a slight trim. In the utube video it shows the ears acually sliding all the way into the slots. Not sure how much to trim. I'm going to install spin lock rods and the front tabs, maybe hinges tomorrow to see how that affects the fitment.

Learned how to remove a convertible top too. With alot of help.

[JBauer]

☹🔫

[BRAN]

Originally Posted by JBauer

☹🔫

ya...the tolerances...bad bad bad

:ah:

Just kidding, did you try the other one? That should fit.
(those are TOTALLY different in size/angle)

[JBauer]

Originally Posted by BRAN

ya...the tolerances...bad bad bad

:ah:

Just kidding, did you try the other one? That should fit.
(those are TOTALLY different in size/angle)

Oh ��
As you probably realized I not much the mechanic, never thought of that. No trimming yet.
Couple updates tho. Spinlocks enraged but bolts not tightened, no front inserts and hinges not bolted up yet, drivers side:


Passenger side, bow in decklid ��



Front wo tabs or rubber:

[JBauer]

Originally Posted by BRAN

ya...the tolerances...bad bad bad

:ah:

Just kidding, did you try the other one? That should fit.
(those are TOTALLY different in size/angle)

☹ sadly the won't work no matter which way side they are on. Holes are the same distance apart. Wrong parts or sloppy QC. I tried everything this time. Suggestions? Try to wallow out each hole alitte to see if I can get them to work?