Quote:
Originally Posted by steved0x
The first time I did a suspension I took this axle nut off because I was also doing wheel bearings.
Every other time I used a custom spring compressor that I borrowed from a friend, that let me take out the rear struts without having to remove the axle nut or remove the LCA. A regular spring compressor may work especially if your original suspension is blown out and easy to compress once the spring is compressed. I think there may be a few videos out there showing shortcuts.
One I never got a chance to try would be removing the sheet metal brace and the two diagonal supports (figure 1 here), and then loosening the inner LCA, with that brace and the supports out of the way I bet that would let the LCA drop down pretty far and the strut top might slide right out  |
no need to remove the braces...inner control arm, toe in ball joint and the fork connection to the LCA gave me the clearance to remove and replace strut. I did loosen the axle nut and floated the shaft back a few inches...needed that.
his/hers
Threaded Mode
