Seal removal on Dual Row IMSB

[Troutman]

Well thanks for the tip but I caved in and went ahead and bought an LN dual row as well as clutch, DMF, RMS etc etc...
Ironically if I was keeping the car, and I might after all this expense, i would have left it, it was more if I was going to trade it in for a 997, much easier to sell a car that's had the IMS/RMS done together.
The tools I bought were junk, they are going back, the puller has an ID of 47 mm, the same as the OD of the bearing..impossible.
I'll do another post when I get the bearing changed.

[JFP in PA]

Originally Posted by Troutman

Well thanks for the tip but I caved in and went ahead and bought an LN dual row as well as clutch, DMF, RMS etc etc...

Good move............

[Boxstard]

Originally Posted by Troutman

Well thanks for the tip but I caved in and went ahead and bought an LN dual row as well as clutch, DMF, RMS etc etc...
Ironically if I was keeping the car, and I might after all this expense, i would have left it, it was more if I was going to trade it in for a 997, much easier to sell a car that's had the IMS/RMS done together.
The tools I bought were junk, they are going back, the puller has an ID of 47 mm, the same as the OD of the bearing..impossible.
I'll do another post when I get the bearing changed.

Please post when you replace the original dual row bearing, curious to see its condition.