Any progress on V8 engine swap options?

[78F350]

Originally Posted by itsnotanova

Do you have any pictures of your creation? I've been thinking of doing one for a long time.

I don't have any pictures, but I'll post some later. It is still very rough. The front is cut just outside the seams and generally follows the seams back. It is removed from the frame except for the front bar and an arch near the roll bar. It was set it up with fiberglass poles (from a tent) arching from the windshield to back under the clamshell and bungee cords securing it to the top of the struts. After testing it, I think it will be better with a support that clamps on over the roll bar. This one isn't going to be sexy, just a little ragged shade that I can carry in the trunk or frunk.