yeah i don't know how you guys are doing this on the welded tip models, i'm just tearing up the tip now.
Tried punching a small hole to start, can't seem to get it with a long flat-head or an actual punch at the end of a long file I have. any other suggestions?
edit: got it, just used the large flat head screwdriver and a hammer and punched out a 7/8" x 3/8" rectangle. Couldn't get anywhere with a drill. Took about 15 minutes once I figured out the technique. Haven't started it up, we'll see how it sounds tomorrow, if I can notice a difference.
edit: There is a slight difference in noise level, but i do like it. It's really pretty tough to notice, which is good. no drone whatsoever.
just a note, don't forget to take the tape off the exhaust tip before you leave for the day...
Threaded Mode
