IMS Replacement

[token 00]

Just had the single row pro installed with clutch, RMS, flywheel and AOS at Chris' in Seattle. New oil and filter - yes! Lucky to have one of the preferred installers in my backyard. Only have a couple hundred miles on the new bearing - so far so good.

I'd get the clutch done too if you're going in for the IMS. At the very least you should be saving yourself a new flywheel purchase and an additional 8 or so hours of labour in the future.

Cheers,
Token

[BobRickel]

I used the EPS IMS solution after doing extensive research on all of the options available. Mine has been in for about 9K miles at this point. I run the heck out of my 1997 and thus far no problems. It only had 40k miles on it but I was concerned about dependability so I replaced all the rubber coolant hoses, the front motor mount, the Air/Oil separator, the water pump (was starting to wobble), the plugs and plug tubes, the rear main seal and the fuel and air filter and anything else I could think of. Here is a video with a cutaway of the EPS IMS solution.