IMS bearing removal without special tool??

[JFP in PA]

Originally Posted by nmdarby54

Hi, I am in the process of replacing my IMS bearing with a new one from LN. In doing research I have not come across any info on anyone removing the bearing without the special tool from LN.. I was curious if anyone has had any success in removal WITHOUT the special tool, and if so. How did you go about removal?

Thanks

It is not just a matter of getting the old bearing out, you also have to get the new one in without killing it. As some have actually gotten themselves in trouble using the correct tools but not following the correct procedure's, you would be well advised to get both the tools and instructions and do it correctly. You can always resell the tools later.

[Topless]

I remember a few years ago when a DIY wrench tried to replace the IMS with out the tools or procedure. He meticulously documented as he FUBAR'd his motor. It was like watching a slow-motion train wreck.

Clue: Get the tools and if you don't have the knowhow or talent, hire it. Once the trans is out of the way it is maybe 2 hrs labor for a skilled tech.