Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 07-06-2017, 05:00 AM   #1
Side Porsche
 
Join Date: Jan 2015
Location: Tn
Posts: 157
I am going to follow this as well. I fixed my noise by replacing the valve under the intake. But I still occasionally hear it at 3000ish rpm. I think that it may just be the hole+speed of air = perfect setup to howl.

I hope that someone figures it out eventually. As like most of you I am tired of throwing money at it.
__________________
2001 Silver Box
mipstien is offline   Reply With Quote
Old 07-07-2017, 12:11 PM   #2
Registered User
 
Join Date: Feb 2016
Location: New England
Posts: 296
Quote:
Originally Posted by mipstien View Post
I am going to follow this as well. I fixed my noise by replacing the valve under the intake. But I still occasionally hear it at 3000ish rpm. I think that it may just be the hole+speed of air = perfect setup to howl.

I hope that someone figures it out eventually. As like most of you I am tired of throwing money at it.
I just ordered the valve for the fuel filler neck. It's the least expensive of the remaining options, and in my opinion, probably the most likely remaining culprit. I should have it in place by the end of the month. I'll keep you posted.
Need_for_speed is offline   Reply With Quote
Old 07-07-2017, 07:40 PM   #3
Registered User
 
Join Date: Apr 2016
Location: SE Michigan
Posts: 496
Quote:
Originally Posted by Need_for_speed View Post
I just ordered the valve for the fuel filler neck. It's the least expensive of the remaining options, and in my opinion, probably the most likely remaining culprit. I should have it in place by the end of the month. I'll keep you posted.
I am also having this type of noise issue, but only at idle on warmer days above 75F or so with half tank of less fuel, under isolated situation and never noticed it while driving. I changed the filler neck valve which reduced the noise level and duration but still there...

Hope this thread lead to a solution.
__________________
1997 Boxster arctic silver/ red, XNE riveted mahogany/ leather steering wheel & 917-style wood shift knob, Ben’s short shifter, PSE, 996 TB, UDP, stereo/ center console delete, hardtop and speedster humps, daily driver rain or shine or snow!
Boxstard is offline   Reply With Quote
Old 07-08-2017, 10:48 PM   #4
Run
Registered User
 
Join Date: Dec 2009
Location: SC
Posts: 151
I have had this issue for 3 YEARS. Recently (last year) my fuel sending unit started leaking. I have not yet replaced it as the car is sitting in storage. I am wondering if there was an issue with it all these years causing that noise. Mine would always do it at steady rpm let off the gas or brake and the sound was gone. I hope to get around to getting it fixed in the next month or so will be interesting if that damn sound goes away.
Run is offline   Reply With Quote
Old 07-09-2017, 06:55 AM   #5
Registered User
 
Join Date: May 2014
Location: S.California
Posts: 2,029
Quote:
Originally Posted by Run View Post
I have had this issue for 3 YEARS. Recently (last year) my fuel sending unit started leaking. .... Mine would always do it at steady rpm let off the gas or brake and the sound was gone. I hope to get around to getting it fixed in the next month or so will be interesting if that damn sound goes away.
Sounds like this is vacuum related ? Steady rpm = low vacuum, idle/over-run =suddenly much higher vacuum
Gelbster is offline   Reply With Quote
Old 07-11-2017, 02:19 PM   #6
Run
Registered User
 
Join Date: Dec 2009
Location: SC
Posts: 151
I will take a look into the vacuum thing. This is my third car 2nd Porsche and honestly I think its time to go to a new home 2k miles in almost 3 years
Run is offline   Reply With Quote
Old 07-15-2017, 05:37 PM   #7
Registered User
 
Join Date: Feb 2016
Location: New England
Posts: 296
Fuel filler valve -- fail.

So today I replaced the valve on the fuel fill tube, using the Pelican instructions as a guide. It was a tricky little job, but after a lot of fiddling around, I was able to get the new valve in place.

Note: not shown in the Pelican instructions, there's this very slender little electrical component, looks like a transducer, that fits into a corner of the fuel filler valve. The wire attached to it is taped to the fill tube. I noticed it by accident after I removed the old valve. What the heck is this part?

Anyway, we did a test drive and the woo-hoo is still there. It's extremely intermittent, totally independent of throttle position. It almost seems like it has something to do with the way air flows over the car. Now I'm starting to wonder if it's a hood adjustment thing, or if I have a weatherstripping issue somewhere. I've replaced just about every damn component on the evap system, so now I'm grasping at straws...
Need_for_speed is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 03:44 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page