Durametric Won't Connect

[911monty]

Particlewave: I had a similar problem with mine. I bought a new Durametric from Pelican about 6 months ago. Was driving me crazy. It would occasionally connect and then fail. I sent back to Durametric for analysis, they found nothing wrong with the one I had but said they had some issues with some from another batch. Long story short, I finally found that the .NET Framework 3.5 sp1, they said it needed did not contain .Net Framework 2.0. I downloaded the 2.0 and it has been working fine since. Good Luck

[Krieger]

Originally Posted by 911monty

Particlewave: I had a similar problem with mine. I bought a new Durametric from Pelican about 6 months ago. Was driving me crazy. It would occasionally connect and then fail. I sent back to Durametric for analysis, they found nothing wrong with the one I had but said they had some issues with some from another batch. Long story short, I finally found that the .NET Framework 3.5 sp1, they said it needed did not contain .Net Framework 2.0. I downloaded the 2.0 and it has been working fine since. Good Luck

How do you do this? am not a computer wizard, but I could figure this out with some help. I am having the same problems connects to engine, but not airbag?

[911monty]

Originally Posted by Krieger

How do you do this? am not a computer wizard, but I could figure this out with some help. I am having the same problems connects to engine, but not airbag?

Krieger: If your Durametric cable is able to auto select your DME then your .Net framework version is likely fine. Basically this is language that allows the application to run. Do you have a seatbelt fault? I believe this would prevent access to the airbag.