BoxsterLS376 introduction - LS3 conversion :)

[BoxsterLS376]

Originally Posted by Lcrivers816

Oh man you're so close! What did you end up doing for the spacers?

Well still a lot of little details but definitely feeling like we are getting closer! Right now the spacers are out of it until I get the cradle bars in place, although the motor does lean forward a bit more then I would like, enough to see the front urethane motor mounts being pushed forward. I need to make sure everything clears but I may just add about a 1/4" of spacing back into the transmission mounts to level things out a bit.

Originally Posted by Ben006

good job

Ben

Thanks Ben!

[Lcrivers816]

You got this man I'm jealous that you got a lift to work with I'll send you a PM to show you where I'm exterior wise on my build!