3.4L Motor Swap Underway!

[Cloudsurfer]

Looking good! Something to think about when putting this back together, is joining the engine and gearbox out of the car, and then stuffing the whole lump back in. All you have to remove is the cross brace (4 15mm bolts) and you can slide the whole thing back in in one piece.

I find it WAY easier to mate the two out of the car, and it's especially easier to get all the fasteners together that way.

[insite]

agreed on mating the engine & tranny, however, my car simply isn't high enough to clear the subframe without turning the motor sideways. this won't work with the tranny attached. i'd go higher, but my motorcycle jack will not......