Dash Speaker Mounting adapters

[MarkAP]

I would also be interested in the 3D drawings. I have access to a 3D printer.

Thanks

Mark

Originally Posted by Stiglitz

I sent the files to square-root

Install finished, hopefully I can post the pics this weekend

Great improvement, will probably get some Better repeaters within the next couple of months, these were dirt cheap

[Cunningr]

Have you thought about making a solution that would hold a replacement tweeter so you can use components?

I just upgraded or upgrading to Hertz 3 way components and the tweeter mounting became a headache.

Came up with a in-elegant solution of making a couple of small holes and a small zip tie as a strap and some electrical tape. Its working but I am still wanting to come up with a more elegant solution.

[MarkAP]

Stiglitz

Would you mind sending the drawings again? They were in my messages but when I logged in again they were gone

Thanks

Originally Posted by MarkAP

I would also be interested in the 3D drawings. I have access to a 3D printer.

Thanks

Mark

[Stiglitz]

Sent! via pm

[djsick]

I just installed a set of alpine Spg102C and used my factory rings which I modified but can still go back to the originals if I want. Hot glued them to the rings haven't had any issues. Even used the original harness.

Mine had the component tweeter in the grills but deleted them since the alpines where coaxial 2 way speakers. These grills are from a 2002 base model.

The 4inch alpines are a major difference from the original paper weights...