Swapping engines

[JFP in PA]

The reason LN used a Spiralock instead of a snap ring has to do with the original wire ring used in the tube; the Spiralock conforms to the grove machined into the tube better than a flat snap ring would, giving you a superior holding power.

[LoneWolfGal]

I must comment about the quality of LN's products. Beautifully machined, they are almost works of art, worthy of a place on the mantel. Here's an exploded view of the installation tool and the bearing as it's installed in the shaft:

[LoneWolfGal]

Originally Posted by JFP in PA

The reason LN used a Spiralock instead of a snap ring has to do with the original wire ring used in the tube; the Spiralock conforms to the grove machined into the tube better than a flat snap ring would, giving you a superior holding power.

Spiralock! Many thanks, JFP. I've been searching for the official designation. Thanks to you, I found a company with a trick name for theirs, Spirolox, and they have an installation how-to:

https://blog.diamondracing.net/how-to-install-spirolox

[LoneWolfGal]

I managed to get the Spiralock installed, with the help of a small flat-blade screwdriver. I think it's fully in the groove, but I didn't have sense enough to measure the width of the lock before I put it in. Consequently, I can't be sure how much is actually in the groove, which is only a millimeter or so deep. A couple millimeters of the shim can be seen behind the lock. It seems secure. I can't easily pop it out of the groove with the screwdriver. I think it's okay. In fact, I'm almost sure it might be.

[piper6909]

Originally Posted by JFP in PA

The reason LN used a Spiralock instead of a snap ring has to do with the original wire ring used in the tube; the Spiralock conforms to the grove machined into the tube better than a flat snap ring would, giving you a superior holding power.

Isn't the Spiralock flat too?

[piper6909]

Originally Posted by LoneWolfGal

I managed to get the Spiralock installed, with the help of a small flat-blade screwdriver. I think it's fully in the groove, but I didn't have sense enough to measure the width of the lock before I put it in. Consequently, I can't be sure how much is actually in the groove, which is only a millimeter or so deep. A couple millimeters of the shim can be seen behind the lock. It seems secure. I can't easily pop it out of the groove with the screwdriver. I think it's okay. In fact, I'm almost sure it might be.

Looks great! That thing ain't going nowhere!

[LoneWolfGal]

Seated, the bearing was less than a millimeter in from the groove, about the thickness of the shim. Which I figured was the objective. But a little voice is whispering, "What if the bearing isn't fully seated, and there wasn't enough clearance for the lock to fully engage in the groove?" I hate that voice. The only way to shut it up is with experience, but this is the only IMS bearing I'm likely to install. At least, I hope it's the only one.

[LoneWolfGal]

By the way, not to stir the pot again, but Jake Raby refers to the Solution's bearing as a "bushing" here, at 18:12:

https://www.youtube.com/watch?v=XZ87UcYkT7A&t=892s

[JFP in PA]

Originally Posted by piper6909

Isn't the Spiralock flat too?

Yes, but because of its spiral sectional design, it can better conform the bottom of this grove, which is slightly curved, much like a "U" to accept a round wire. A snap ring would not fully seat in this grove.