DIY Clutch Replacement?

[Gelbster]

I used a 2 Post lift. I have seen photos using 4 very tall jack stands.That way the car is level.
The Harbor Freight floor trans jack(scissor type) seems to feature in some but a tall hyraulic cart is probably better?

[jb92563]

I used standard height jack stands from HF. I think I measured 17", but you will have to get the transmission to within 6" of the floor.

I used my floor jack. I drilled some holes in the floor jack pad and bolted a square of 1/2" ply 12"x12" for the transmission to rest on and used load straps to keep it from falling off. Worked perfectly and due to the fact that there was some slack/play it made jiggling the tranny back into place fairly easy.

I don't like jack stands either but nothing budged as your not pushing hard sideways on anything during this job.

[Gelbster]

HF sell 12 ton jack stands that raise the car up to 30"
I use a set of 4 on a diesel truck and regular cars. Rock solid and cheap(on sale)
12 Ton Jack Stands

[CdnRD]

The only issue I see with that is getting the car up to the lowest height of 19.5 inches. 6 Ton axle stands start at about 17 inches so you can get the car to that height using regular 2 or 3 ton stands.