My take on the Magnetic Oil Filter Housing

[Pdwight]

Thanks Steve, I think the duty rating on this is 170C in temp. Is the thickness of a truck tire inner tube...or perhaps a bit thicker....time will tell

[JayG]

Originally Posted by Pdwight

Thanks Steve, I think the duty rating on this is 170C in temp. Is the thickness of a truck tire inner tube...or perhaps a bit thicker....time will tell

Dwight, where did you get the heat shrink?

[Pdwight]

Originally Posted by JayG

Dwight, where did you get the heat shrink?

That was the most difficult to find, lots of folks have 4 inch heat shrink.....but they want you to buy a roll at several hundred dollars..............but ;

https://www.wirecare.com/product.asp?pn=WC53706020

[78F350]

Looks good. I have 2 done so far with the hose clamp. Heatshrink tubing looks like a great idea.
To initially apply the magnets, I used JB KwikWeld. I did them one after the other doing opposing sides of the housing. Even so, they started to slump towards each other a little until I put on zip-tie and the tape. The JB Weld alone may hold, but I am going to do the heatshrink.