Converting 2004 Boxster Power Steering to 12V

[PorscheFan5]

Okay, was able to finish up the installation of the pump and wiring. Some pics attached.

I am taking the '12V Switched' from the fuse box D4 which is an unused spot. I read somewhere on this forum that one can take 12V Switched from there. Had to do some cutting etc to the side of the fuse box but it worked out. I was quite happy with my work... Routed the wire inside and above the steering column to bring it to the center console from where I have made a hole and added a plastic fitting to take it out from there. I am going to need 12V switched in many places and am thinking I will put a bus bar somewhere...

I am also thinking of changing the allen-head bolt, that goes on the pressure plate that keeps the pressure and return line pressed in, to a hex head bolt and be done with it once and for all...

Hope this helps someone else doing the project.

[PorscheFan5]

Quick update and a question...

One checking the 12v that I got from D4 at the footwell fuse box, I found that it shows 12V as soon as the battery is connected and remains 12v so far as the battery is connected

That would mean this is 12V Batt and not 12V Switched (12V On only if switch is turned to ON position). Am I missing something?

Need to find 12V SW if possible from fuse box. Or I will have to tap it from behind the radio?

Please help!

[jsceash]

Originally Posted by PorscheFan5

Quick update and a question...

One checking the 12v that I got from D4 at the footwell fuse box, I found that it shows 12V as soon as the battery is connected and remains 12v so far as the battery is connected

That would mean this is 12V Batt and not 12V Switched (12V On only if switch is turned to ON position). Am I missing something?

Need to find 12V SW if possible from fuse box. Or I will have to tap it from behind the radio?

Please help!

The bundle of wire that is right between your circuit breaker and firewall has a red wire with a black stripe I pulled and spliced into that wire to turn on my pump. Not the same brand as your but it starts my pump with the key.



Mine is mounted in the same location different mount.

[PorscheFan5]

Thanks for the prompt response. I see two bunches there, one a thick one another a thin one. Is this RD/BLK wire in the thin one?

BTW, mine is a 2004 Base Boxster. I checked both the bunches that run parallel to the black bar and neither of them have the RD/BLK wire in my case. I will have to find another way.

I would like to find the 12VSw in the cabin somewhere near the driver side dash. That will make it easy for me to route it since I have created a junction point for 12vSw there...

Any ideas?

[PorscheFan5]

I think I found 12v Sw right where I need it!

In the center console area there is a unused 4 pin connector, that I think is for the phone option. This connector has both 12vBatt and 12vSw. The RD/GRN wire is 12vBatt (continuous) and GRN/BLK is 12vSw (Switched). Checked it with the DVM, and confirmed.

Now I can just wire from right there...

[jsceash]

Yes I'm using that feed to Power my oil gauges and sump solenoid switch. My harness looks different may be it's because I have the lithonics headlight. The lamp control module is next to my pump.

[PorscheFan5]

On further observation, I wish I could find a 12V Sw which has a thicker gauge wire on it. This wire seems to be 14awg max... Anyways it will do well for the current purpose...