Why won't my Conv Top not go back up

[schoir]

Originally Posted by Infernicus

Hi! Sorry for the delay. After much searching around, I still couldn't find a problem. Finally, I took it in. I just got a call back, and it is my right top transmission. I just thought I would let you guys know!

Any thoughts on how hard it is to replace one of these?

It takes about 1/2 hour to remove and replace one of the convertible top transmissions.

After you pull away the foam liner on the inside of the quarter paner, one 19mm nut in the center and three 13mm nuts on the outer perimeter. Instructions are in the link I posted in response to one of your posts.

Regards, Maurice.

[jamesmcd03]

Do you have photos or videos on how to do this? Not clear on how to access this area.

"first place I would look is at the end of each of the two cables that drive the transmissions. You can check them for length to make sure that they are being driven by the electric motor by first lifting up the upside down U clip that holds them against the sides of the electric motor. If the inner cable is not sticking out by about 1/2 inch from the end of the outer sheath, that is probably your problem. Otherwise, you will have to investigate at the other end of the cables (the transmission end).

Thank you,