Wheel Spacer Install Help!

[Sboxin]

52MM lug bolts are needed for the 7MM spacers. You should have 45MM bolts on the stock wheels.

This Automotion site may help you:
http://www.************************************************************/productpage.aspx?pid=102089&name=H%26R+Trak%2b%c2%ae+Wheel+Spacers

Your current bolts may go into the hub, but are not the correct length for adequate strength.

And, as others have said, the round washer/flange needs to be removed
and reinstalled on the new bolts (just hit it hard with a hammer and open
end wrench to get it off)

Take care

[c-c]

[QUOTE=Sboxin]52MM lug bolts are needed for the 7MM spacers. You should have 45MM bolts on the stock wheels.

Well, even with the 7mm they rub a little - the rubber touches just enough. If I had ordered 10mm it would have been perfect.

I ordered 14mm just to be sure so I'll keep you guys posted.

I'll put 14mm on the rear and 7mm on the front. Anyone see a problem with this setup?

Also, it's wierd that the H&R spacers are held on with only one screw.

Thanks for the help everyone.

-c