Quote:
Originally Posted by mikesz
the 2 top bolts don't have to come off just loosen them. I went to Harbor freight and got a set of long handle box wrenches. Loosened those 2 top bolts just enough to get it out. As far as the 2 lower bolts, I lowered the engine on the scissor jack an inch or 2 just enough to pull it out just like Pedro's directions say and I was able to get the motor mount out.
|
Thinking about it. I don't think I lowered the engine enough. The top two bolts were fine to loosen although a bit tight up there. It was the lower bolts it was just too long to remove it fully.
I will have another go at it. Hopefully this time I get it right. Will take the advice on board.
Threaded Mode
