Accusump install

[AZ986S]

Originally Posted by JFP in PA

Check the engine number on the sump rail; willing to be it has an "AT" in it, but the numbers will tell you what year it was designed for.

I looked this evening and could not find any markings around the sump. Where are the numbers located? Not on the sump plate itself I hope?

[JFP in PA]

Originally Posted by AZ986S

I looked this evening and could not find any markings around the sump. Where are the numbers located? Not on the sump plate itself I hope?

[AZ986S]

OK found it.
New engine is M96/21AT67Y65274
Looks like it was a reman engine M96 version 2.1 model year 2006.

[AZ986S]

Update...

I ran at Wild Horse Pass last weekend and the new engine performed flawlessly. Seat of the pants feels like more power than the old engine since it is a 2006 rebuild. I recorded some in cab video and was reviewing to see how often the accusump came on. In general, right turns will activate the accusump more than left turns. It never activated for more than maybe 1 or 2 seconds at a time. I had my passenger look at oil pressure and temperature (ambient air temp was 95F), and pressure never came much lower than 40 psi, temp never higher than 225F. I am using Mobil 1 5W50 oil. Oil capacity now is almost 11 quarts, so that probably helps in keeping oil temps down.

So I am very satisfied with the results. The next thing I would do is add a pressure sender to the air side of the accusump and a switch on my panel to use the existing oil pressure gauge to read the air preload pressure. This had been suggested by StevedOx.

[michaelpetersen3]

This is a great write up!

Im considering an Accusump for my 01S that sees a lot of track duty. Wonderful build with the Accusump in the tunnel and the switch on the pressure gauge for oil/Accusump.

One question, I have a journal bearing on my IMS (L&N IMS Solution). There is an adaptor plate on the oil filter joint to feed the IMS bearing. I would assume that I can add the Accusump pick up plate to the IMS adaptor plate. Its a little bit of a Rube Goldburg design, but it should work. Or, can I tap into the Accupump plate for an additional small oil pickup to feed the bearing? Has anyone tried this?

Great thread overall, thx for the morning entertainment.

[michaelpetersen3]

Finally finished the install of the accusump on my '01 986 S. Installed it in the tunnel, it fits well and seems to be the most logical location.

Here is a video of the results on the track with track tires. I run my oil level about half way between low and full, with this set up I get an accusump dump on almost every corner and even under heavy breaking. Based on the video there are even a few longer corners where the accusump runs dry. Running Mobil 1 0W-40, BTW.

I also run into very low oil pressure at idle post track sessions, i.e 5-7 PSI at idle and 250 F oil temp.

Conclusion: If you're tracking a 986 or 996, strongly consider an Accusump or deeper oil pan, you'll need it.

Video Link - https://youtu.be/lp-PJr1aPtA