Swapping engines

[Hamstuh]

Originally Posted by LoneWolfGal

More proof the compression tool was made of soft metal and therefore the defendant is not just a careless idiot who overtightens things. If it please the Court, I present the following photograph as Exhibit 1:



Note the 6mm wide, 1mm deep channel in the shaft near the threads. The nut was full of metal bits from the damaged threads and therefore difficult to turn, so the defendant used a pair of small vice grips to hold the shaft. Apparently, the vice grips weren't cinched down enough, so they carved the channel during a single rotation of the shaft. A channel of this depth could not be created so quickly unless the metal was soft.

And so, ladies and gentlemen of the jury, I submit to you that this entire fiasco resulted from too-soft metal and therefore LoneWolfGal is innocent of boneheaded workmanship.

The defense rests.

quite the rollercoaster of emotions all for this tool that i now need to buy for my timing job. just off all of this im thinking Pipers nudge towards building the special tool 9632 from the youtube video might be ideal and effective with time and price

[LoneWolfGal]

The engine's at the new place. This was taken just after it was unloaded. I had been sweating unloading it, but I needn't have worried, and I didn't have to use the come-along after all. I merely guided the engine while it sailed down the 4x8 ramp in stately fashion. It began gathering momentum toward the bottom but then it encountered the stack of moving blankets I'd placed there. I attribute the trouble-free unloading to the heavy-duty 4" wheels (with brakes) I installed on the pallet. Moving the 500 lb engine around on a level surface is easy as pie.

[Gilles]

Originally Posted by LoneWolfGal

The engine's at the new place. This was taken just after it was unloaded. I had been sweating unloading it, but I needn't have worried, and I didn't have to use the come-along after all. I merely guided the engine while it sailed down the 4x8 ramp in stately fashion. It began gathering momentum toward the bottom but then it encountered the stack of moving blankets I'd placed there. I attribute the trouble-free unloading to the heavy-duty 4" wheels (with brakes) I installed on the pallet. Moving the 500 lb engine around on a level surface is easy as pie.

Welcome to your new home!

[LoneWolfGal]

Originally Posted by Gilles

Welcome to your new home!

Thanks, Gilles. I'm not finished moving yet, but one more trailer load should do it, except for the Porsche. I'm going to rent an auto hauler for it from U-Haul next week and deliver that 986 to its new digs in style. Then I'm going to kick back for a while to recharge. Moving is rather taxing. As in totally exhausting.

[piper6909]

Do you have AAA? You can get a free tow on a flatbed.

[LoneWolfGal]

Originally Posted by piper6909

Do you have AAA? You can get a free tow on a flatbed.

Al, I had AAA a couple years back but didn't renew it, because State Farm has roadside service. I'm leaning toward using a "tow dolly," which lifts the front and leaves the rear wheels on the road to freewheel. Everyone I've talked to says tow dollies are the way to go for light cars.



https://www.uhaul.com/Trailers/Tow-Dolly-Rental/TD/