Quote:
Originally Posted by Pdwight
A system I have used on mechanical projects in the past that has worked well for me ( and I am by no means telling you how to do this)
Take a piece of cardboard or poster board and trace the "thing" ( water pump , Head bolts , Browning A5 Receiver etc.
Where bolt goes make a "T" incision with an xacto or pointy slim knife. As you remove the bolts or screws insert them into the cardboard example, they will stay in place and you will not lose track of where they go.
|
That's what I did too. Two of the water pump bolts are longer than the other two, but i think there was something on the pump that would tell you which if you didn't notice when taking them off, either a bevel on the back or a little edge or something to help align the pump when installing.
Threaded Mode
