bearing carrier-next ?

[fasted911]

On my book i came across this page notice #1 bolt(cannot find it.) it is a m9x150mm i found bolts #3 & #5 from this diagram.so i when to local dealer and ordered #1.
Question #1-right when i drop bearing carrier in 1,2,3 crankcase half and 2 gaskets are there any more o-ring or gaskets?
question #2 than add 4,5,6 crankcase half than the #1 bolt in center top of picture than bolt #3 & 5????

alright.here is this pic of halves and hardware

[BYprodriver]

Yes just a couple O-ring type gaskets for crankcase halves. Did you get a full rebuild gasket set? There are many O-rings required, Those long bolts have O-rings, before you install the heads, install those 3 long bolts finger tight. After you torque the heads, then torque the 3 long bolts.