I did clean up all the edges with the cutting wheel and a file so now they are all pretty. Sorry I didn't take a pic of that. I have not made a a patch piece for the muffler section yet. When I head out today I will pick up some apoxy and use a piece of the cut up box that is readily available right now on the floor of my garage.
In the car
Test fit of the maf. Still needs a clamp on the maf side.
This is where I am at for now. Maybe later on this evening after hours (baby sleeping) I will head back out and put the manifold and fuel rail back in.
Side note:
Anybody know if it is ok to reuse the injector o-rings? There in good shape, they were replaced when I put the motor in. If they are reusable, should I oil/lube them or anything?
Thanks for the info on that.
J
__________________
996 3.4 engine with 2.7 986 5speed transmission
Ebay Headers, Fabspeed high flow cats, JIC Cross, IPD Plenum, H&R Coilovers, B&M Short Shifter, AEM Uego Gauge Type Analog, Apexi S-AFC Select, 987 air box, Litronics, 2000 Tails and side markers, painted center console, 18" 987 S-Wheels, GT3 Front bumper with splitter.
Last edited by JAAY; 03-15-2012 at 09:43 AM.
|
Threaded Mode
