|
at this point, perhaps just confirm that the dme has power and see if you can pull an obd signal direct from the unit. here's what i have for 2002 pinouts for that connector:
Connector I, 9-pole
Pin Designation Pin Designation
1 Terminal 15 - switched power
2 Terminal 30 - always on power
3 W-wire - OBD
4 Ground, electronics
5 Ground, fuel injectors
6 Ground, output stages
7 Throttle motor actuator
8 DME relay terminal 87 - pretty sure this is permission from immobiliser to turn on
9 Throttle motor actuator
Last edited by The Radium King; 05-18-2018 at 02:37 PM.
Reason: just to note that these are for a 2002 996, not 986 ...
|
Threaded Mode
