Quote:
Originally Posted by The Radium King
dunno if it will help, or has anything to do with this, but i have spares for the two connectors that plug into the back of the litronic headlights. i got mine used, and once installed you can't remove the wiring harness without cutting these connectors off. so, i had to replace mine. it was a HUGE search for me to find them online, but i did and they sent a couple of extras.
|
Thanks - They might come in handy at some point.
I purchased my litronics used as well. I installed the harness and wiring to activate the low-beam rotation feature. Now, I have the bright idea of installing the dynamic leveling system. (You can read about it here: http://986forum.com/forums/general-discussions/55840-can-you-endure-one-more-litronic-thread-me.html)
If I can move 6 pins from the connector I showed in the picture to the one installed in my car, I can simplify the wiring considerably. The other option is to remove what I already put in and build a wiring loom that attaches to the salvaged harness that I bought. However, as you indicate in your post, the connectors that attach to the lights are too big to fit through the holes in the front trunk.
I was wondering if this might be the pin that they used in the connector: http://www.repairconnector.com/deutsch-female-open-barrel-replacement-terminal-16-18-ga-5-pack/
If it is, I could just insert them into my existing connector.
__________________
2000 Arctic Silver/Black, Hard Top, On Board Computer
PNP Rear Speakers, HAES 6-Channel Amp, Avic Z140BH,
Painted Bumperettes, 2004 (OEM) Top, Homelink integrated in dash with Targa switch, 997 Shifter, Carrera Gauge Cluster with silver gauge faces, heated 997 adaptive sports seats, Litronics, silver console
Last edited by KevinH1990; 02-15-2015 at 06:15 PM.
|
Hybrid Mode
