Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

 
 
LinkBack Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-22-2014, 06:08 PM   #8
Registered User
 
Join Date: Sep 2008
Location: Florida
Posts: 2,497
Well, it can be expensive if you have the work done and depending on what you end up doing.

If a CV joint is bad, you might as well source a half axle. Prices vary from under $100 used to $400 for new. The bearing is cheap..under $50.

Thing is, if you are going to replace the axle, go ahead and do the bearing (and vice versa) as the labor involved is similar.

I repacked CV boots ($10 each) and replaced a bearing a few years back. Took me about 4 hours. I was on a lift and had access to a press to R/R the bearing.

If you have this done, figure on $400-$600 labor.
dghii is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 06:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page