Jake R., others: Help with IMS-G wiring install

[kjc2050]

Getting ready to wrap up my IMS-Guardian installation. Before putting the car up on jacks, I thought I'd have the route for the wiring harness mapped out and ready to go.

So... I pulled all the carpeting/padding from around the engine, leaving me here:


You can see the wiring and the connector for the IMS-G on the floor. But when I began pulling the lower section of carpet away from the bulkhead, I was unable to see any bulkhead plugs...



Just looking for a little reassurance and perhaps a tip... should I keep going in this area? Can anyone point me in the right direction? Closer to the center of the car? Toward the driver's door? Would I be better off on the passenger's side? (It looks the same, by the way, but I haven't gotten down near the floor yet on either side.)

Appreciate any help anyone can offer... thanks.