View Single Post
Old 11-17-2012, 07:05 AM   #1
kjc2050
Registered User
 
kjc2050's Avatar
 
Join Date: Oct 2012
Location: Wake Forest, NC
Posts: 867
Garage
Jake R., others: Help with IMS-G wiring install

Getting ready to wrap up my IMS-Guardian installation. Before putting the car up on jacks, I thought I'd have the route for the wiring harness mapped out and ready to go.

So... I pulled all the carpeting/padding from around the engine, leaving me here:


You can see the wiring and the connector for the IMS-G on the floor. But when I began pulling the lower section of carpet away from the bulkhead, I was unable to see any bulkhead plugs...



Just looking for a little reassurance and perhaps a tip... should I keep going in this area? Can anyone point me in the right direction? Closer to the center of the car? Toward the driver's door? Would I be better off on the passenger's side? (It looks the same, by the way, but I haven't gotten down near the floor yet on either side.)

Appreciate any help anyone can offer... thanks.
__________________
2000 Boxster S, 6 speed, Sport Package, Litronics, LED tail lights, LNE IMS-B, OBC, Skybreaker wind deflector, Arctic Silver/Graphite Grey
kjc2050 is offline   Reply With Quote