|
It's really pretty simple:
Tools needed:
T-20 anti-tamper (hole in the center) bit or driver
Removal:
1. Put top in service position, remove top box, carpet and engine cover
2. Locate sensor and pull off electrical connector
3. Remove both T-20 screws
4. Pull old sensor
Installation:
1. Fit the new sensor with seal and tighten the screws to 2.0 − 3.0 ftlb (3 − 4 Nm).
2. Plug the electrical connector back in.
3. Replace top box, carpet and engine cover.
4. Replace top from service position.
|
Hybrid Mode
