Accellerator sensor

[Paul]

Those codes can be thrown when pedal encoder 1's voltage is not 2X of pedal encoder 2.

I always check the wiring from end to end with a ohm meter for each of the 6 wires before replacing anything. All 6 wires must have similar resistance for the system to work properly.

[Paul]

Pinouts:

Pin 1 at pedal sensor to connection 12 on DME plug IV (ground sensor 2)
pin 2 to 8 (signal sensor 1)
pin 3 to 14 (5V supply sensor 2)
pin 4 to 9 (5V supply sensor 1)
pin 5 to 7 (ground sensor 1)
pin 6 to 13 (signal sensor 2)

[jb92563]

Are you looking at an e-gas system gas pedal assembly or the Throttle body.

I have spares of both from my 01 'S' that turned out OK when I found it was my ECM had malfunctioned.

I'd sell them to a forum member for a good price.

Sounds like its the pedal components you want.