|
I fabricate aluminum and brass. I have had one Boxster plastic tank failure and a junk generic replacement.I thought about making a replacement for a nano second because I am slow .My limited skills tell me this is not a practical project. The tank is easy.The fittings would be very,very difficult.They are not generic so the fabricator can not just braze on a stock fitting to a custom tank - that is the usual method. If you are thinking about cutting off the existing plastic fittings and gluing them on to a custom aluminum or brass tank ..... cough, that won't last very long.
Some other manufacturers have the same problem and their tanks are similar price e.g. Land Rover.
Last edited by Gelbster; 08-16-2016 at 02:37 PM.
|
Threaded Mode
