Sorry if this is a stupid question, but I couldn't find help by searching the interwebs.
I have the SAI codes (p0410 p1411) on my 99 base and I was trying to replicate this test with the Durametric Enthusiast.
http://www.renntech.org/forums/topic/47862-help-diagnosing-possible-sai-problem/
Looks like this person was able to start the engine with the Durametric already logging actual values. I was not able to start the engine with the cable in and program booted up. Is there some trick to this?
In any case, as fast as I could get booted up, and before the air pump shut off, I was seeing the pre-cat sensor oscillate so I guess I'm not getting air to the exhaust.
Not sure I have the intestinal fortitude or know-how to remove the intake and go further so into the shop it goes.
Threaded Mode
