Another Camshaft devation question

[sweeper]

Thanks for the information...very much appreciated.

After a nice warm up this morning I hooked the car back up- I activated bank 1 and 2 cams- and got a nice pull down from each just at idle. The car did not die but dropped significantly and returned after I stopped.

I then pulled cam 1 and 2 up and got the same deviation as indicated (1 @ "0" and 2 @ "- 9") then I attempted to activate the cam banks while watching the deviation- each time I tried it locked the program up and I had to get completely out of the program and re-start to get any communication??

I took the car for a drive again while monitoring the deviation on both cams- Got it out on the highway and reached the + 4k RPM mark numerous times with no fluctuation whatsoever?

I am going to remove the software from my computer and reload and try again tomorrow? Any suggestions?

Oh...all is not lost- I spent the entire day in the car- 80 degree day......... what deviation? who cares!! Thanks again!