rear toe way in, no more adjustment... camber too.

[chaudanova]

Originally Posted by insite

the toe and camber settings in back strongly affect one another. until you get new toe links, set your current toe links to max toe out. then, adjust your camber until the toe zeroes.

as for a permanent solution, you'll need aftermarket toe links. they're available from Tarrett Engineering and also from Che at Delubozparts (ebay). Che's are fairly affordable (see here: http://cgi.ebay.com/ebaymotors/Porsche-986-Boxster-97-05-Adjustable-Rear-Toe-Arms_W0QQcmdZViewItemQQcategoryZ33583QQihZ020QQite mZ300154881897QQrdZ1QQsspagenameZWD1VQQtrksidZp163 8Q2em118Q2el1247)

no matter what you go with, it's a good investment to buy the concentric bolt locks from Tarrett. the concentric toe adjusting bolt has a tendency to move; these hold them in place so they don't move when you drive. they'll also prevent an alignment shop from using the concentrics to adjust toe rather than the double adjusters on the aftermarket links.

I spoke with Ira (the owner of Tarrett), and he said that these couldn't hurt, but aren't really needed on the boxster... He said that because of the design of the 996/997, that they help on those models, but the boxster design is different and not really necessary. Do you find that your toe gets out of alignment right now without these?

[mn box s]

No it stays put, all the way out (as far as that is). Thanks for getting back to me, Ill be getting Che's toe bars and if I have problems later on with them going out of adjustment Ill get in touch with Tarretts. Thank you! ... now any advise on a certain rear camber kit?

[chaudanova]

For rear toe arms, what do you guys think about Che's arms, compared to the designs by Tarett, TRG, ERP, GMG, etc...

Che's arms:





Versus more traditional proven style from Tarett/TRG/ERP/GMG








Any analysis/breakdown from the different designs?

[insite]

i think che's might be a little better on the hub end. the tarretts & TRG's both use a stock porsche tie rod, which a lot of racers complain about. the porsche motorsport links on the cup cars and RSR's use a bearing with a pin like che's.

[CJ_Boxster]

Originally Posted by mn box s

No it stays put, all the way out (as far as that is). Thanks for getting back to me, Ill be getting Che's toe bars and if I have problems later on with them going out of adjustment Ill get in touch with Tarretts. Thank you! ... now any advise on a certain rear camber kit?

If You've bought Che's upper rear control arms, you can adjust them forward to get the toe-in you want. Thats what i did when i lowered my boxster.