Quote:
Originally Posted by Pdwight
How much are they going to cost ?
|
As I say on the top of this page, around 300$, but I will depend on wethet I need to paint it or not
Quote:
Originally Posted by heliguy
Will you be testing this set up on the dyno? You mentioned testing in a week.
|
I will try to get it on the dyno, but I can't garantee it :/
The testing will be more about reliability. I will put it on my car, and abuse it, then take it off and see if there is any problem.
Then, if I decide that it's good, you will get some
Quote:
Originally Posted by Bfan
I am impressed. Good luck with your CEL. They can be a PITA.
I might be interested in buying one from you if/when they become available although I already have a 997 Plenum. Your design will get the throttle body a little lower and my intake setup cleaner.
|
I hope the sensor was the problem, will see next week if the CEL comes back.
Yes, the TB will sit at the stock location
Ben
Threaded Mode
