Swapping engines

[JFP in PA]

You need what is call a "pass thru socket" set:

https://m.media-amazon.com/images/I/91kvbpIVoDL._AC_SL1500_.jpg

The sockets have a large thru opening that the screw driver can pass thru and uses a special rachet that grips the flats on the outside of the butt end of the socket:

[piper6909]

Originally Posted by JFP in PA

You need what is call a "pass thru socket" set:

https://m.media-amazon.com/images/I/91kvbpIVoDL._AC_SL1500_.jpg

The sockets have a large thru opening that the screw driver can pass thru and uses a special rachet that grips the flats on the outside of the butt end of the socket:

I recommended a similar set to her about a week or so ago, but she she said she needs a 12-point thin-walled socket and these appear to be neither.

[LoneWolfGal]

Originally Posted by JFP in PA

You need what is call a "pass thru socket" set:

https://m.media-amazon.com/images/I/91kvbpIVoDL._AC_SL1500_.jpg

The sockets have a large thru opening that the screw driver can pass thru and uses a special rachet that grips the flats on the outside of the butt end of the socket:

Now that you mention it, I would actually love to have a set of those. However, I'd be surprised if the set's 7/16" socket has a small enough outside diameter to fit in the notch and on the nut, since few do. You've installed a number of Solutions and you must be aware of the flange notch's small size, making access to the nut difficult with standard tools, so what do you use to tighten the center stud's nut?