It's difficult to be that because the car is running ok with no failures nor rough idling, but I'll check it next. I was hoping to find what happened before taking the engine out
It's difficult to be that because the car is running ok with no failures nor rough idling, but I'll check it next. I was hoping to find what happened before taking the engine out
Regardless of how the engine is still running, that is on Hell of a lot of ferrous metal from a mostly alloy engine. Something is seriously wrong, and continuing to run it is likely to make it even worse. Shut it off, hide the key, and take the engine out before something bad becomes disastrous.
__________________
“Anything really new is invented only in one’s youth. Later, one becomes more experienced, more famous – and more stupid.” - Albert Einstein
Regardless of how the engine is still running, that is on Hell of a lot of ferrous metal from a mostly alloy engine. Something is seriously wrong, and continuing to run it is likely to make it even worse. Shut it off, hide the key, and take the engine out before something bad becomes disastrous.
IMHO, if it still runs well, ignore JFP.
Get a friend to record the video and go have some fun with what's left of it:
...and maybe another friend with a fire extinguisher.
__________________ I am not an attorney, mechanic, or member of the clergy. Following any advice given in my posts is done at your own peril.
I'm going with IMS bearing. Don't run the car. Turn it over to TDC by hand. Lock it there. Remove tranny and follow the procedure to remove the IMSB cover. That means loosening tensioners etc. I'll bet the bearing is missing the bearing cage and a side shield. I'm way less squeamish about metal in the oil than most forum members. If it is the bearing there's a good chance you caught it in time and can just slap another $10.00 fully sealed greased bearing in its place. I know heresy, but more likely than not you'll fix the problem. If you put an open bearing in, the metal debris will kill it in short order. You need a fully sealed bearing.
It's difficult to be that because the car is running ok with no failures nor rough idling, but I'll check it next. I was hoping to find what happened before taking the engine out
Remove the oil filter & stick your longest finger into the hole where the filter mounts. Feel for metal shavings inside. If you find metal there it has circulated thruout the engine & you need to find another one.
__________________
OE engine rebuilt,3.6 litre LN Engineering billet sleeves,triple row IMSB,LN rods. Deep sump oil pan with DT40 oil.
Parts Car, car parts
Honda Del Sol(s)
"Hers"
My Original '99
The 78 F350
This
That
The S 2.5
Other
Mean Motor Scooter
Hybrid Mode
