Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

 
 
LinkBack Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-10-2016, 08:04 PM   #11
Engine Surgeon
 
Join Date: Aug 2008
Location: Cleveland GA USA
Posts: 2,425
Quote:
Originally Posted by particlewave View Post
Also worthy of note is that FACT that LN bearings do fail regularly, but every time someone posts online about it, Jake Raby and a few of his minions immediately attack the poster and blame him, the engine or the installer. Sometimes to the point that the poster removes the post completely. Over the years, I've witnessed this behavior on at least half a dozen occasions. Very shady stuff...

I'll never buy an LN bearing.
Anything can fail... But when something goes south the posted will seldom post the full story. Like the guy that had a dealer do the retrofit procedure, and they didn't even change the engine oil, which had been in service for a year prior! Or the technician that was using impact tools to tighten the center IMS stud nut...

Within the next 45 days or so the amount of LN IMS Retrofit components sold will break the 28,000 mark; with that many retrofits being done, all over the world, and mostly by those who are NOT Certified Installers that have been trained, things will happen.

For the record, there have been zero failures of the IMS Solution. This is a fact.

To date there have been ZERO failures of any IMSR products that were installed by a Certified Installer. This is a fact.

Also, we have performed over 500 IMSR procedures here under my roof, including the very first one. To date we have not had a single failure, of any of the technologies that LN sells. This is also a fact.

The installation DOES matter, and too many shops pay techs on flat rate, where they have to race the clock to make a decent pay check at the end of the week. This promotes negligence, hastiness, and typically does not allow for enough time to inspect and "qualify" an engine prior to the IMSR procedure. That takes 4-6 hours here, but most shops want the job done, and running in 10 hours. Its a recipe for disaster that no one has control over.

That said, you'll not find a single direct customer of ours that has a complaint, or whines on these forums. Our customers are like Smshirk, and they appreciate what we do for them. The whiners, and haters are always the guys that take issue with something, and have not spent a single dollar here. I have no idea why they do what they do, but I have to admit, it is entertaining.
__________________
Jake Raby/www.flat6innovations.com
IMS Solution/ Faultless Tool Inventor
US Patent 8,992,089 &
US Patent 9,416,697
Developer of The IMS Retrofit Procedure- M96/ M97 Specialist

Last edited by Jake Raby; 04-10-2016 at 08:08 PM.
Jake Raby is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 06:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page