Pedro Bar / Stabilizer bar etc

[casioqv]

Originally Posted by ike84

Instead of dropping $100, I bought a 3/4" square x24" long bar of extruded aluminum, knocked out the OEM bolts, and drilled the bar to fit. I positioned mine above the diagonal braces so that it's completely out of sight.

Could you share a photo of this? It's hard to visualize exactly what you did, but I am interested in trying it.

[ike84]

Originally Posted by casioqv

Could you share a photo of this? It's hard to visualize exactly what you did, but I am interested in trying it.

Yes, I'll get a pic of it tomorrow

Sent from my SM-G970U1 using Tapatalk

[Robert986]

So, I can report that I put in a 20x30mm bar, this is a bit too wide and it hits the exhaust just a bit. Just FYI :-)

[ike84]

Originally Posted by casioqv

Could you share a photo of this? It's hard to visualize exactly what you did, but I am interested in trying it.

Here are the pics. Like I said, it's quite concealed. It runs on top of the sheet metal brace, connecting the two rear most bolt holes on the diagonal braces. It tucks under the exhaust on either side (my exhaust is totally custom though so I can't speak to OEM setups) and then bolts drop down from the top and go through the bar, the sheet metal brace, and diagonal brace) and secured via a nut on the bottom side. The oem bolts here just knock out from the bottom-up.

Sent from my SM-G970U1 using Tapatalk