Brey-Krause bracket on factory sliders?

[fridsten]

There it is! I had some things to figure out and adjust. The distance between the holes in the seat brackets was too short, so I had to expand the rear hole by a couple of millimeters. That wasn't too difficult.

But getting the plug for the power seat disassembled so I could remove the seat belt buckle was quite a challenge. Still, the buckle is a bit too short, so I might get a longer one or an extender for it. Any suggestions?

The seating position is very good, though.



Edit: That's glue residue on the backrest. I had a minor issue with the seat padding...

[Robert986]

Originally Posted by fridsten

There it is! I had some things to figure out and adjust. The distance between the holes in the seat brackets was too short, so I had to expand the rear hole by a couple of millimeters. That wasn't too difficult.

But getting the plug for the power seat disassembled so I could remove the seat belt buckle was quite a challenge. Still, the buckle is a bit too short, so I might get a longer one or an extender for it. Any suggestions?

The seating position is very good, though.



Edit: That's glue residue on the backrest. I had a minor issue with the seat padding...

Looking good!

I needed to get closer to the floor (too tall) so had to skip the slider, but yours looks like a great solution. Regarding the seatbelt, I´ve seen there are extensions, not sure which ones fits the 986 however.