Interior vent debris

[78F350]

1. I ended up pulling out the console, which had already been modified for a 2 DIN head unit.
2. Cut the duct so I could peel it down out of the way and temporarily taped it.
3. My foam was COMPLETELY gone, otherwise I would have cleaned the flaps.
4. Covered the flaps with a heavy duct tape that has a long lasting, thick adhesive.
5. Tested the operation to make sure nothing was blocked and the tape was secure.
6. Put it back together and used the same tape to seal the duct.

Relatively quick and painless. YMMV depending on your center console configuration.:dance:

[Carlton Bale]

Originally Posted by 78F350

1. I ended up pulling out the console, which had already been modified for a 2 DIN head unit.
2. Cut the duct so I could peel it down out of the way and temporarily taped it.
3. My foam was COMPLETELY gone, otherwise I would have cleaned the flaps.
4. Covered the flaps with a heavy duct tape that has a long lasting, thick adhesive.
5. Tested the operation to make sure nothing was blocked and the tape was secure.
6. Put it back together and used the same tape to seal the duct.

Relatively quick and painless. YMMV depending on your center console configuration.:dance:

This is awesome. Seems like relatively easy access to both flaps.

No issues getting your hands/arms in the hole to the bottoms of the flaps?

[78F350]

Originally Posted by Carlton Bale

This is awesome. Seems like relatively easy access to both flaps.

No issues getting your hands/arms in the hole to the bottoms of the flaps?

I used strips of tape that were between two and four inches long. At first I tried poking them in with a trim tool, but using my hand worked best. With the flaps in the resting position, it was difficult, but doable. I think that the best access was with the AC running and the fan on low. I poked my camera in for this shot, then put on one more piece of tape to caver a gap:

[ExplorerLyon]

Has anyone else followed this method? I need to fix the foam in my vents and this seems like the easiest method.

Originally Posted by 78F350

1. I ended up pulling out the console, which had already been modified for a 2 DIN head unit.
2. Cut the duct so I could peel it down out of the way and temporarily taped it.
3. My foam was COMPLETELY gone, otherwise I would have cleaned the flaps.
4. Covered the flaps with a heavy duct tape that has a long lasting, thick adhesive.
5. Tested the operation to make sure nothing was blocked and the tape was secure.
6. Put it back together and used the same tape to seal the duct.

Relatively quick and painless. YMMV depending on your center console configuration.:dance: