Yes I am
 

I make each one up by hand so after payment I can usually get you one in the mail is 3 to 5 days. Paypal me $45 as a gift and I will get you one on the way

Cable
 

Great, who do I pay pal that too?

Sent, thanks

Thank you for your order

Will be in the works and out soon

On it's way....sorry for the delay

Thanks again

Dwight

Received cables today. Beautiful. Thanks Dwight.

Thanks, I appreciate the kind words

Embarrassing but I want to do this enough to say - I lost the instructions that came with my cable(dash switch version) and I don't know exactly how to install it. Has anyone done any install instructions that I missed? I know there was some talk about this.

Pdwight, do you have any pics that you can share for the likes of me please? :)

Thanks.

If you PM your email, I can send you a PDF of the original build/install instructions from yosief.

Has anyone installed using the dash switches to control the OBC features? When reading the instruction on the Pelican website it states "To use this switch with the OBC, wire pins 2,3,4,5 from the table above to pins 1 and 2 of two different switches, and then connect the green ground wire to pin 4 of both switches." - This would mean you need 2 switches correct? Would you also need two of the white harnesses from Dwight?

I think you need 2 switches to simulate "up-down" and "front-rear".
1 harness should suffice, like for the stalk addition.

Thanks for clarifying.


Sent from my iPhone using Tapatalk

Have to be honest with you
 

I would go with a 4 stalk, they just do not cost that much and look factory...you can do it with one switch and just step through the displays...I can make you as harness either way you go.

Thanks

Dwight

Would someone be able to confirm that the OBC stalk from a 4 stalk part number 99661321910 for a 911 or a 996 would work for the 986?


Sent from my iPhone using Tapatalk

Yes, they should work for the 986.

The OBC full parts list can be found here. I just did mine and t works great.

Porsche Boxster On Board Computer (OBC) Upgrade and Turn Signal Switch Replacement - 986 / 987 (1997-08) - Pelican Parts Technical Article

Dwight, I sent you a PM.

Harness
 

Hello,
Are you still selling this?
Would it be possible to make a harness that goes to 2 switches?
Rj thomas
rj.thomas93@gmail.com

Yes, I am still making these. So you want 5 conductors with leads for two switches ?

Would you simply like push on female crimp connectors (I will of course solder as well as crimp)

Yes, I think so. So that would be 4 signal and 1 ground leads?
Yes push on crimps are great for the switch end.