Quote:
Originally Posted by ben2000
To do that, you are supposed to remove the dash/gauge cluster first.
I was not able to get that done unfortunately. The instructions stated "D: Lift the gauge cluster up so that you can disconnect the wire harnesses on the back.".........but in my case I couldn't get the thing to lift off far enough (it seemed stuck on something I couldn't see on the driver's side moreso --- i'm guessing the wiring to the 3 cable harnesses on my car just didn't have much slack). ...
|
I just recently did all of this, replacing the steering lock and ignition switch:
http://986forum.com/forums/561000-post63.html
Are you sure that you removed the actual hazard switch as shown in figure 5 of this? :
https://www.pelicanparts.com/techarticles/Boxster_Tech/102-ELEC-Instrument_Cluster_Bulb_Replacement/102-ELEC-Instrument_Cluster_Bulb_Replacement.htm
__________________
I am not an attorney, mechanic, or member of the clergy. Following any advice given in my posts is done at your own peril.
|
Parts Car, car parts
Honda Del Sol(s)
"Hers"
My Original '99
The 78 F350
This
That
The S 2.5
Other
Hybrid Mode
