Tie rod removal problem.

[san rensho]

Does the nut turn. If it does then get a sacrificial torx/hex bit and jam it in the stripped torx. You should then be able to hold the bolt so you can get the nut off.

[Gilles]

If I were in your shoes, I would jut cut the nut with a dremel.
You will still have plenty of fun left trying to remove the ball joint from the arm...
Good luck

[Disaster]

Originally Posted by Gilles

If I were in your shoes, I would jut cut the nut with a dremel.
You will still have plenty of fun left trying to remove the ball joint from the arm...
Good luck

Ditto on that. Have had to do the same thing before. Dremel groove followed by nut splitter.

[jeeper31]

Originally Posted by san rensho

Does the nut turn. If it does then get a sacrificial torx/hex bit and jam it in the stripped torx. You should then be able to hold the bolt so you can get the nut off.

The nut is frozen on the torx. I don't think I can get another torx in there.

[911monty]

Try a nut splitter?