Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 09-10-2005, 06:40 AM   #1
Registered User
 
Brucelee's Avatar
 
Join Date: Jun 2004
Location: Des Moines, IA
Posts: 8,083
Conventional DINO oil IS shot at 3K.

I use M1 in my wife's Subaru and change it at 5K.

Seems to work fine.





Quote:
Originally Posted by donv
There is (or at least was) an incentive for car companies to set longer oil change intervals, from the EPA or similar forces in governments everywhere. Back when we had effective CAFE regulations and the like, there was great pressure to reduce the amount of not just gas but also oil consumed. An easy way to do this was lengthen change intervals. The same folks that figured out it was cheaper to not fix the Pinto gas tank problem probably also were able to model when the engine would fail, on average, at change interval x+y%, so the car company execs could please the EPA. I'm sure it was/is targeted to be at some comfortable point past the factory warrany period.

I experienced this the hard way with my first "bought new" car... an '84 Honda CRX. Factory change interval (just extended at the time) on that was said to be 5K miles (conventional oil). I had previously always changed at 3K on all the used cars I'd owned before, with good long engine life. Following the 5K on the Honda got me a smoker by the time it hit ~70K miles.

I'm back to a religious 3K interval on my conventional oil cars since and they've all lasted well past 100K with no oil consumption. I'm doing every 10K or min. yearly on the Boxster with M1. With the oil being recycled now, I'm not worried that I'm ruining the planet with this practice - quite the opposite. By having the car last longer, that is one less vehicle that needs to be made as long as it lasts, saving energy and other resources consumed in the mfg. process. And of course, fewer steep new car depreciation cycles for my wallet, too.
Brucelee is offline   Reply With Quote
Old 09-16-2005, 12:13 AM   #2
Registered User
 
Join Date: Sep 2005
Location: Minneapolis/St. Paul, Minnesota, USA
Posts: 3,308
Hi,

There is some pretty good evidence that changing the oil at the 3k mi. interval actually increases wear to the Engine and it's internals.

I know this seems counter-intuitive, but Engine wear actually decreases as oil ages. This has been substantiated in testing conducted by Ford Motor Co., ConocoPhillips, and reported in SAE Technical Paper 2003-01-3119.

What this means is that compulsive oil changers are actually causing more engine wear than the people who let their engine's oil get some age on it.

To add some perspective to this, I agree with the 10k mi. or annual (if less than 10k mi.) oil and filter change. Additionally, most of the dirt and particles which pass thorugh your Air Filter end up in your oil. If you live in (or have driven extensively through) dusty areas, or use a K&N Type oiled Filter, you should shorten the change interval. Hope this helps...

Happy Motoring!...Jim'99

Last edited by MNBoxster; 09-16-2005 at 02:31 PM.
MNBoxster is offline   Reply With Quote
Old 09-16-2005, 05:41 AM   #3
Registered User
 
Brucelee's Avatar
 
Join Date: Jun 2004
Location: Des Moines, IA
Posts: 8,083
Talking

Jim 99 is dead on with his post.

I too have seen this research on engine wear right after an oil change.
Brucelee is offline   Reply With Quote
Old 09-16-2005, 05:29 PM   #4
Registered User
 
Join Date: Aug 2005
Location: Central Florida
Posts: 182
Regarding the factory run-in of the motors Yes, Porsche runs every motor on an engine dyno prior to installing it in a car. As for the number of miles, that's unknown but they do run it through a computerized "break-in" then make power pulls to confirm output. The oil is then drained and replenished when it's finally installed in a car.

That would pretty much eliminate the need for a 1000 mile oil change.

BTW, if a motor doesn't make it's spec rated HP it's torn down to analyze why. Because of this continuing analysis they have very few motors that don't make the grade.

Here's a quote directly from the Porsche website:

The following hot test is the final step in the engine production process. The engines are first of all heated up to operating temperature and then subjected to a functional test including full-throttle testing. Information in the form of up to 220 parameters is generated in this test of around five minutes' duration.

This ensures that Porsche's high quality standards are also met in the area of engine construction.
mjw930 is offline   Reply With Quote
Old 09-16-2005, 06:08 PM   #5
Registered User
 
Brucelee's Avatar
 
Join Date: Jun 2004
Location: Des Moines, IA
Posts: 8,083
" generated in this test of around five minutes' duration."



With all due respect, the text reads like a PR piece from Porsche. Having seen the metal shavings from a 1000 mile oil change, I would keep doing them.

5 minutes? Give me a break!

Brucelee is offline   Reply With Quote
Old 09-16-2005, 06:11 PM   #6
Registered User
 
Join Date: Sep 2005
Location: Minneapolis/St. Paul, Minnesota, USA
Posts: 3,308
Quote:
Originally Posted by mjw930
...That would pretty much eliminate the need for a 1000 mile oil change.

BTW, if a motor doesn't make it's spec rated HP it's torn down to analyze why. Because of this continuing analysis they have very few motors that don't make the grade.

Here's a quote directly from the Porsche website:

The following hot test is the final step in the engine production process. The engines are first of all heated up to operating temperature and then subjected to a functional test including full-throttle testing. Information in the form of up to 220 parameters is generated in this test of around five minutes' duration.

This ensures that Porsche's high quality standards are also met in the area of engine construction.
Hi,

You'll excuse me if I'm somwhat underwhelmed. Porsche may in fact run up their engines to confirm performance specs.

Too bad they don't also perform Quality and Durability tests, especially with respect to the RMS and Intermediate Shafts. These persistent Quality failures (prevelant through the entire 986, 996 model runs, with no apparent improvement through the years) are unconscionable for a Company with the past reputation for reliability. I mean, even Kia got this one right!

Happy Motoring!... Jim'99

Last edited by MNBoxster; 09-16-2005 at 07:41 PM.
MNBoxster is offline   Reply With Quote
Old 09-17-2005, 09:32 AM   #7
Registered User
 
Join Date: Aug 2005
Location: Central Florida
Posts: 182
Quote:
Originally Posted by MNBoxster
Hi,

You'll excuse me if I'm somwhat underwhelmed. Porsche may in fact run up their engines to confirm performance specs.

Too bad they don't also perform Quality and Durability tests, especially with respect to the RMS and Intermediate Shafts. These persistent Quality failures (prevelant through the entire 986, 996 model runs, with no apparent improvement through the years) are unconscionable for a Company with the past reputation for reliability. I mean, even Kia got this one right!

Happy Motoring!... Jim'99
Jim,

I'm not saying that they don't have their problems and I don't want to get into a pissing contest regarding Porsche's QC.

The question at hand was regarding factory specified oil change intervals and the discussion surrounding the factory's run-in proceedure. Here there can be no question, Porsche specifies the oil change intervals, including the initial change, based on their analysis of test data. If you choose to deviate from that formula then you do so at your own risk. As evidenced by some published scientific data more (sooner) is not always better.

I personally never bought into the 3000 mile change intervals. Those have been engrained on the population by the Jiffy Lubes of the world for the sole purpose of boosting their bottom line. No major engine manufacturer ever specified those intervals for normal driving conditions.

I think if you were to get access to the engineering data within Porsche you would find that even with the 15,000 oil change interval the oil's ability to protect the engine is well within spec. I wouldn't doubt if their data shows acceptable wear well past 20K intervals. Rest assured that they are not going to specify longer intervals at the risk of higher warranty claims.

Oh, and one more thing regarding the "5 minute" dyno runs. That is the portion of the run after the initial warm up phase that puts the engine through it's paces. On a modern computer controlled engine dyno you can properly break in an engine in a matter of minutes. Again, more is not always better.
mjw930 is offline   Reply With Quote
Old 09-17-2005, 10:03 AM   #8
Registered User
 
Brucelee's Avatar
 
Join Date: Jun 2004
Location: Des Moines, IA
Posts: 8,083
"I personally never bought into the 3000 mile change intervals. Those have been engrained on the population by the Jiffy Lubes of the world for the sole purpose of boosting their bottom line. No major engine manufacturer ever specified those intervals for normal driving conditions."

Actually, the 3K change with DINO oil was not a bad thing. DINO oil performance drops off VERY QUICKLY as it wears, SYN does not. The hard analysis that I have seen on DINO would support the 3-5K changes with DINO, not SYN of course.

"I think if you were to get access to the engineering data within Porsche you would find that even with the 15,000 oil change interval the oil's ability to protect the engine is well within spec. I wouldn't doubt if their data shows acceptable wear well past 20K intervals. Rest assured that they are not going to specify longer intervals at the risk of higher warranty claims."

I have never seen data (even from AMSOIL) that would support 15 to 20 K changes UNLESS the oil filter was changed at about 12,500 or so.

M1 is pretty much shot at 11-12K without an oil filter change.

I would be ASTONISHED if Porsche had hard data that showed that m1 could run 20 K without an oil filter change and be up to snuff.

In fact, M1 extended perf oil is only claimed to be good to 15K. AMSOIL will guarantee 25K IF you change the filter about half way.


"Oh, and one more thing regarding the "5 minute" dyno runs. That is the portion of the run after the initial warm up phase that puts the engine through it's paces. On a modern computer controlled engine dyno you can properly break in an engine in a matter of minutes. Again, more is not always better."

I would love to see some back up for this statement. Break in has to do with bearings, metal to metal, and ring seating. How does the computer speed up that process?

I do think the "bashing" you refer to is valid. If Porsche specifies 20K on the oil, it would have more credibility if it had many less failures to explain.

PS- I love Porsche but am not blind to their blindness on certain issues.

Brucelee is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 10:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page