Brucelee

Can I get help moving a thread I started in tech into DIY? That may be a better place for that. It's the wheel bearing tutorial. Thanks.

Bruce, How do I move an inquiry from one forum to another. I think maybe I put it in the wrong place, Technical as opposed to General?

hi bruce sorry my last post seems to have infringed your parameters...but dont understand why?

Hello -

I posted a for sale ad in the Boxster section, it worked fine, then I put one in the Cayman section and it didn't. I thought I did something wrong, so I did it again, this time I saw a message saying that the ad had to be approved first, or something to that effect:-) It only lasted a few seconds and then went away. In any event, I will have two identical ads once someone decides I am legitimate, I'm sorry about that, my fault.

I do have a question, I just realized looking at what I did in the title I said it was 2005 and it is 2006, is it possible for you to change that if I cannot?

Best regards,

Mark Smith

No luck on my end either

Brucelee:

I've been trying to contact mmontfort about his post on the ELM 327 device he mentioned on the race forum for pulling OBD data, to no avail--PM's included.

Could you email him--since he doesn't post much--and ask him to respond to me via email or PM?

thanks
MikenOH

It never occurred to me before, but thought I'd offer to be an admin if you need an extra one. I'm the #2 poster on the board behind you, and I'm here every day and watch the daily postings.

I won't have my feelings hurt if you don't take me up on the offer, so no worries there. Just thought I'd make the offer if you needed some help.