Hi Everyone,
I hooked up my Durametric today to check all of my actual values against what they should be. There were a few readings that where a tiny bit off, I am hoping someone can let me know if everything looks good, or if there is anything I should be concerned about or monitor more closely. Car was warm at idle, but not fully at operating temperature. Also, what are Segment A & B?
18kg/h Spec Air Mass
Expected: 15.5 +/- 0.25
3kg/h Spec Air Adaptation
Expected: 1.5 +/- 0.05
1.9ms Injection Time
Expected: 2.2 +/- 0.1
1.00 Range 2 Cylinder 1-3 (FRA)
1.00 Range 2 Cylinder 4-6 (FRA2)
Expected 0.96 +/- 0.03
-3.0crk Camshaft Position 1 Deviation
-3.0crk Camshaft Position 2 Deviation
Expected: 0 +/- 4
1 Segment (A)
Expected 0.01
1 Segment (B)
Expected 1.0
Thanks,
-Rick
