Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums

Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: 77'911s
Forum: Performance and Technical Chat 12-10-2017, 07:57 AM
Replies: 6
Views: 1,478
Posted By 77'911s
You might check the level first. I know this is...

You might check the level first. I know this is not fun if you don't have a lift. If the trans was not serviced in a long time(IE 80-100k), sometimes it takes 2 services to right it. I have to...
Forum: Boxster General Discussions 12-06-2017, 10:52 AM
Replies: 10
Views: 1,143
Posted By 77'911s
Surprised you didn't go with Fabspeed since they...

Surprised you didn't go with Fabspeed since they are in your back yard. Wish your friend was in the PNW. ; )
Regards
Forum: Boxster General Discussions 12-06-2017, 09:04 AM
Replies: 10
Views: 1,143
Posted By 77'911s
Hits the flange for the trans mount. I could not...

Hits the flange for the trans mount. I could not even get the the flange by the 1st cat to button up flush. The angle is off that much. The guy at Top Speed was exceedingly nice and pleasant, offered...
Forum: Boxster General Discussions 12-06-2017, 06:56 AM
Replies: 10
Views: 1,143
Posted By 77'911s
That's not a bad idea, but we don't have anyone...

That's not a bad idea, but we don't have anyone around here that can do that type of work.
Regards
Forum: Boxster General Discussions 12-05-2017, 07:06 PM
Replies: 10
Views: 1,143
Posted By 77'911s
Maybe I'll give them(Dansk) a try. Tried TopSpeed...

Maybe I'll give them(Dansk) a try. Tried TopSpeed version(low cost, fits only manual cars) and Fabspeed (waay too short and Fabspeed would not help other then weld extensions on??). Hoping to find a...
Forum: Boxster General Discussions 12-05-2017, 02:01 PM
Replies: 10
Views: 1,143
Posted By 77'911s
Anybody running Dansk 2nd Cat Bypass Pipes?

Looking to hear if anybody has them and what their experience was with them? The Tiptronic in our 2002 is seemingly posing some fitment issues with some pipes out there. Thanks for any comments you...
Forum: Boxster General Discussions 12-03-2017, 10:26 AM
Replies: 15
Views: 1,447
Posted By 77'911s
I'd just replace the whole AOS, clip(comes set up...

I'd just replace the whole AOS, clip(comes set up to drop in), upper pipe(996-107-145-06), and lower seal. You should not need to remove the wheel. That lower bolt is easy enough to access without...
Forum: Performance and Technical Chat 11-28-2017, 03:31 PM
Replies: 17
Views: 4,443
Posted By 77'911s
Interesting, the one's I've gotten were made in...

Interesting, the one's I've gotten were made in china and the detonation quality was terrible. I've tried them all, as we have multiple 986's in the family. The 01 we have came with Beru's when new...
Forum: Boxster General Discussions 11-28-2017, 03:22 PM
Replies: 10
Views: 1,887
Posted By 77'911s
I'm going to vote ignition switch and lock...

I'm going to vote ignition switch and lock assembly. There were garbage when they built these cars. Same thing happen to our 01 and 02 units. Installed the new updated assembly and all electrical...
Forum: Performance and Technical Chat 11-24-2017, 06:28 PM
Replies: 17
Views: 4,443
Posted By 77'911s
Beru, for this application(IE Boxster). Bosch...

Beru, for this application(IE Boxster). Bosch are terrible, foul easy, poor quality(made in china, most of them except some oldies). NGK are not bad, but I don't think they have the heat range quite...
Forum: Boxster and Cayman Parts for Sale or Wanted 11-24-2017, 06:22 PM
Replies: 1
Views: 758
Posted By 77'911s
Bump, found a "S" muffler, but still need bypass...

Bump, found a "S" muffler, but still need bypass pipes for a 2002 base tiptronic. Anybody putting their car back to stock?
Thanks
Forum: Performance and Technical Chat 11-07-2017, 06:40 AM
Replies: 5
Views: 980
Posted By 77'911s
Loose steering, check tie rod assemblies. The...

Loose steering, check tie rod assemblies. The inner's on these cars have a tendency to go early. You should not be feeling vibrations, check your motor and trans mounts. If they have not been done,...
Forum: Boxster General Discussions 10-11-2017, 07:40 AM
Replies: 11
Views: 2,126
Posted By 77'911s
Make sure the oil they use is the factory stuff....

Make sure the oil they use is the factory stuff. I found on our 986, new motor/trans mounts along with a 997 shifter housing made a vast improvement to the car. The mounts are particularly bad on...
Forum: Boxster General Discussions 10-04-2017, 08:23 AM
Replies: 5
Views: 1,057
Posted By 77'911s
I just did motor and trans mounts on our 2002...

I just did motor and trans mounts on our 2002 base(80k on car). It got rid of a vast amount of vibrations, clunks, and noises(rattles and the like) throughout the car. The newer gen motor mount is a...
Forum: Boxster and Cayman Parts for Sale or Wanted 09-29-2017, 08:09 AM
Replies: 1
Views: 758
Posted By 77'911s
WTB 2nd Cat Bypass pipe(2.7) +03-04 Muffler

Hi
I'm looking for a secondary cat bypass pipe set for our 2002 986 base(2.7) Tiptronic car. Also looking for a 2003-2004 muffler from a Base car or S. Thanks.
Regards
Forum: Boxsters and Cayman Cars for Sale or Wanted 09-29-2017, 08:01 AM
Replies: 0
Views: 747
Posted By 77'911s
WTB 2nd Cat Bypass pipe(2.7) +03-04 Muffler

Hi
I'm looking for a secondary cat bypass pipe for our 2002 986 base Tiptronic car if anybody has one, and wants to sell. Also looking for a Muffler from a 2003-2004 986 base or S, preferably with...
Showing results 1 to 16 of 16

 
Forum Jump


All times are GMT -8. The time now is 10:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page